Notifications
Clear all

rays pixels

109 Posts
36 Users
0 Reactions
27.8 K Views
Materdaddy
Posts: 2368
(@materdaddy)
Famed Member
Joined: 16 years ago

I have been tossing my dead GECEs in the trash... I'll start saving them. Thought about saving them for null pixels, but for the most part, I usually end up cutting the dead ones w/ short leads to give me a little slack in my repair soldering. I'll start cutting more toward "half way".


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Yeah I did the same. I tossed about 25 at the beginning of October when I was putting them out. I've got another 3 or 4 now. One is a bad output joint that's mostly holding up with proper tension. The others are all bad colors.
I've been kicking around a new pixel design in my head and I've been watching threads like this trying to figure out how I want to handle the manufacture process.
When you guys are talking about injection molded pixels, what material is being molded?

--Jon Chuchla--

Sent from my iPhone using Tapatalk


Reply
Posts: 2128
(@livermore-dad)
Famed Member
Joined: 16 years ago

I'm sure I've got a couple, will look around and donate to the cause.

tory


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
pcmom wrote:I will do other brands, but I can think of no value to do GECE as clearly GE is not interested in this groups analysis (especially if they are dropping the product line, which it appears they are), unless the value is that you think this might allow you to repair them yourself, but I suspect that the decap process destroys them.

Lets limit this for now to small vendors...

I would disagree with this - while I do agree that GE probably couldn't give a squat what some DIY'ers find out, it might be good to get the failure mechanism to ensure future DIY focused stuff could be made better. If we find it's all water ingress for example, then better waterproofing would be high(er) priority as well as perhaps helping a LOT of folks that have GE's on methods to prevent the failures.


Reply
griffixdc
Posts: 2512
(@griffixdc)
Famed Member
Joined: 16 years ago
budude wrote:I would disagree with this - while I do agree that GE probably couldn't give a squat what some DIY'ers find out, it might be good to get the failure mechanism to ensure future DIY focused stuff could be made better. If we find it's all water ingress for example, then better waterproofing would be high(er) priority as well as perhaps helping a LOT of folks that have GE's on methods to prevent the failures.

id have to agree with this with caution since it is in their best interest to do the testing themselves to have a more mediated analysis rather than an outsiders so called analysis. But with this datasheet of possible failure points and enough people submitting them to GE it might raise a flag to someones eye. As for Ray and his stuff i think it will be more effective, since i am sure he is not trying to sell us bogus equipment (we'd stop ordering from him) i think more people need to exclaim to him the problems rather than just throwing them away and saying oh well.... i have watched a lot of videos on this forum and can point out on almost every video a user of pixels because there are some noticeably burnt out/not working pixels and when most work but a few then i doubt it is user error unless it was an injection or end point.

gathering a real analysis of these pixels is what we need as leverage to take an educated and proactive approach to informing Ray or who ever of their failure of a product....i will also suggest people relay the ratio or percentage of bad pixels with-in their order to give a failure rate diagnostics.


Reply
Page 20 / 22
Share: