Notifications
Clear all

rays pixels

109 Posts
36 Users
0 Reactions
27.8 K Views
Posts: 792
Topic starter
(@boarder3)
Noble Member
Joined: 19 years ago

I'd rather pay MORE than having a show that don't work after 2 weeks


Reply
Posts: 214
(@gary-martin)
Estimable Member
Joined: 18 years ago

Yeesh, I don't know what you guys have been buying from Ray but I'm in the range of about 3,600 pixels and my failure rate is something like 2 or 3 *pixels* per year and that's on my older 2801s for the Megatree. Those are the F8 Strawhats, what some of you call "bullets" and I've found that the silicone around the strawhat can let moisture in and it gets to the circuit board. That's why I don't buy F8 Strawhat pixels anymore but only epoxy potted 5050s.

Someone asked what the difference is, Silicone potting, you can move the potting with your fingernail, it's soft and pliable. Unfortunately that also means it can pull away from the wires or frame and let moisture in.

YOU SHOULD ONLY USE EPOXY POTTED PIXELS OUTSIDE!

There, was that obnoxious enough? 😉 Epoxy potted stuff is rock hard. It still *can* let moisture in but it's rather unlikely. I have epoxy potted pixels in my Firefli fixtures that I have been using since 2008 and they're all STILL working perfectly. My 2801 F8 Strawhats on my megatree are epoxy potted on the bottom, but the tops are only protected by the silicone surround. My snowmen are TSL3001 strips, epoxy potted and I've yet to have a single pixel fail on them. This year I added a ton of Pixabulbs, zero failures there (Epoxy potted 5050 trichips) and a load of ws2811, epoxy potted strips on my Bellagio poles and epoxy potted ws2811 rectangular and round nodes on my arches.

If any of you bought that IP 66, silicone potted stuff from Ray, you shouldn't be putting it outside without additional protection. Frankly I wouldn't buy it at all, even to put under eves because with the weather we have around here, water gets everywhere.


Reply
Posts: 347
Posts: 2229
(@plasmadrive)
Famed Member
Joined: 15 years ago

Got my problem fixed.. turns out I just had one pixel go south. Mine are actually 2812 flex strips.


Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

Do you have any spare WS2812's and the tools to replace them?


Reply
Page 10 / 22
Share: