Rain proof power su...
 
Notifications
Clear all

Rain proof power supply

12 Posts
9 Users
0 Reactions
3,622 Views
Posts: 27
(@mfrost55)
Eminent Member
Joined: 13 years ago

Here's the key to maintaining the rain proof :

"◦MUST BE MOUNTED VERTICALLY TO MAINTAIN RAIN PROOFING"


Reply
jeffl
Posts: 250
Topic starter
(@jeffl)
Reputable Member
Joined: 18 years ago

I'm more curious about snow proofing.


Reply
Posts: 184
(@micromutt)
Estimable Member
Joined: 12 years ago

IMO it has holes in it so I don't imagine it's anything proof. Snow will blow into the holes. Rain will splatter into the holes. Moisture will blow into the holes. Fog and humidity will enter the holes. You have to protect the holes or it needs a container or like someone said check DIYLE or many other sources for waterproof supplies.


Reply
Posts: 972
(@dmoore)
Noble Member
Joined: 17 years ago

The term "Rain Proof" is a common one used in electrical enclosures such as:

http://www.austinenclosures.com/products/view/type_3r_rainproof_boxes

If you need WATER PROOF due to conditions such as being directly submerged in water, salt water exposure or other harsh environment, you should purchase a 100% sealed PSU and not a rainproof.

Rain proof enclosures are intended to be water resistant when mounted correctly and these power supplies are no different. They should be mounted no less than 20" from any accumulated snow or from the ground. They do have vent holes and a fan on the bottom to exhaust air due to their high wattage (this is why you typically don't see 350+ watt PSU's that are 100% sealed.)

In 2014, we only had two confirmed environmental failures of these units - both were used in salt-air environments.

Thanks,
David
HolidayCoro.com


Reply
Posts: 194
(@bhoff)
Estimable Member
Joined: 18 years ago

Like everything else, I can see where you could have problems with these, if not used properly. Just like you could have problems with the waterproof enclosures everybody uses. These enclosures have holes in the bottom for the wires to come out, if you mount them upside down, or sitting on the ground, so snow and water could get in them, I would imagine it could get dangerous. In my experience, water will not travel up hill. There are "not" holes everywhere on this power supply, like someone said. There are holes in the bottom for cooling and the fan (which is exhaust, not intake), but there is a "big" red arrow on the case that says "UP". I really don't see any more problem with using these power supply's than using plastic enclosures , with holes in the bottom, for our "very expensive" electronic controllers. But of course, I haven't used the power supplies yet outside, so I may have to eat my words, but it won't be the first time, and probably not the last.

Bill


Reply
Page 2 / 3
Share: