Quick question abou...
 
Notifications
Clear all

Quick question about 2 power supplies & 1 controller

5 Posts
3 Users
0 Reactions
1,484 Views
Posts: 133
Topic starter
(@byhova)
Estimable Member
Joined: 9 years ago
[#52767]

I have a box with 2 power supplies powering a F16V3. 1 power supply for V1 & one power supply for V2 for the controller. I was going to just run 2 power cords 1 for each supply and plug them into the same outlet on the house. But I was wondering could I just run 1 plug to supply 1 and then run 3 jumpers (10awg wire) from supply 1 the Hot, Neutral, and the Gnd to the same of power supply 2?

I am NOT wanting to connect any of the V+ or V- together. Just wondering about the 3 wires to power on the 2nd supply or would I just be better off to run 2 power cords 1 for each supply?


4 Replies
HEMISixty
Posts: 66
(@hemisixty)
Trusted Member
Joined: 6 years ago

If I understand this correctly, yes, you can do that. As far as the second supply is concerned, the first supply is just a physical terminal block. You can do that...


Reply
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

depending on the house outlet, you need 14 awg or 12awg wire between the supplies. each supply draws about 4a.


Reply
Posts: 133
Topic starter
(@byhova)
Estimable Member
Joined: 9 years ago
MartinMueller2003 wrote:depending on the house outlet, you need 14 awg or 12awg wire between the supplies. each supply draws about 4a.

Ok so that setup would work, so should I use 12awg wire rather than 10awg? The house outlet is 12/2 on a 15A breaker.


Reply
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

15a breaker needs 14awg wire. thicker is ok. thinner is bad.


Reply
Share: