Question About Pixe...
 
Notifications
Clear all

Question About Pixel Types

5 Posts
4 Users
0 Reactions
1,605 Views
Posts: 88
Topic starter
(@dsteward)
Estimable Member
Joined: 12 years ago
[#45314]

Have a question. I am getting ready to rebuild a few of my props, including expanding my MT to 32 strings of 75 pixels and adding some matrix columns. I am trying to figure out which pixels to get from Ray. I have been using mostly 12mm Square pixels, but would like to know the differences, pros and cons, between the square and the straight pixels. Is one or the other brighter, lasts longer, etc....

Just trying to figure out which ones to order.

Thanks,

David


4 Replies
stallionent
Posts: 1460
(@stallionent)
Noble Member
Joined: 13 years ago

Bullets and square are about the same in all respects. I run my at 30% intensity.


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

When using ws2811 Pixels, the square nodes and the bullet nodes often use exactly the same components, just a different physical layout, with no difference in brightness, color saturation or longevity.


Reply
Posts: 128
(@emuney18)
Estimable Member
Joined: 11 years ago

Performance wise they are the same from what I've gathered from the forums. There used to be a waterproof issue with some of the squares but that has been fixed. This is all based on people's comments because last year was my first pixels.
Things to consider is spacing. Nodes can be fitted closer together than squares. Squares are easier on the thumbs for inserting into mega tree strips. Some squares have a more flat back profile which could be good for your matrix columns.

Sent from my iPhone using Tapatalk


Reply
Posts: 88
Topic starter
(@dsteward)
Estimable Member
Joined: 12 years ago

Thanks folks. I wanted to make sure that I was not sacrificing anything by using the square pixels. Almost all of the pixels I have right now are square.

Thanks Again


Reply
Share: