I know that the PX1 is suppose to handle(control) a max of 200 pixels if I am not mistaken.
Has anyone pushed a PX1 to the limit (or close) on number of pixels?
I have only used one for a small amount of pixels, but was thinking about moving into a bigger project.
I understand about having to do power injecting after about 50 pixels. Just wondering about the PX1's performance when controlling close to it's stated limit.
Hope to use the PX1s so as not to have to move into more expensive and complicated controllers.
thanks in advance
bert-nc
Side question, can you run all 200pixels from one port?
I did 179 with no issues at all
This Christmas I had the following 82pixels/PX1 - 196pixels/PX1 - 63pixels/PX1 total of 341pixels on with 3 PX1 on one port.
Thanks. Going to be running 3 rgb arches with 50 pixels each off of port. So I should good
