Barnabybear wrote:
I think this is proberbly a querk in the way testing has been done, dating back to when a universe was the maximum you could have on an output. The only way I can see round this to check is to set the E628 to 512 channels on the configuration page whilst you are testing and set it back when you get to running sequences.
Thanks for the reply and suggestion. I have now had a go at modifying the channels on the E682 and re-testing. As you suggested I set universes 1,2,3 & 4 to 512 channels and saved the settings. I then did the controller test to see if there was anything odd and it worked fine. I went to the FPP test and it did the same behaviour as described earlier. eg. no change. I changed the channel outputs in FPP to 512 also, restarted FPP and went back to the FPP test page. It made no difference at all.
I am sure you're on the right track here. When I tick the "reverse" box and re-test the failure is in a mirrored position. This clearly shows that there isn't some kind of pixel problem, but is a software/universe issue.
I'm wondering if this has something to do with the new firmware that I'm using? I have a second E682 board that I still need to build. It has the original firmware on it still. I think I need to build it over the next few days and, if it actually works right away, test again.
SOLVED !!
After the message from Barnabybear I went back and tried a number of other configurations that originally didn't seem valid. I left the controller set to 510 channels per universe and changed FPP to 512. I immediately saw the problem was no longer there!
I then went into xLights and changed all the universes there to 512 and the test patterns from that tool began working perfectly too.
It works now but I don't really understand why. I'm confused that mixing 510 channels/universe & 512 channels/universe is somehow working.
Does anybody have an explanation of why this is working?
Here's a test pattern with 3 of the 4 sections in place. This stuff is really cool!
