Power Supply Equati...
 
Notifications
Clear all

Power Supply Equation

14 Posts
8 Users
0 Reactions
4,652 Views
Posts: 14
Topic starter
(@samami)
Eminent Member
Joined: 8 years ago
[#51785]

Aloha,
I have been looking (and failing) for the equations to figure out how many pixels can be powered per power supply. I see people saying it's like 530 pixels for a 350W PS, but I want to understand where that number comes from. Does it change based on brightness? I'm sure this has been asked before so sorry that I couldn't find it.
Also I realize this is really general with no specifics and that's because I'm looking for the generalities. I plan on running 5V and 12V in my designs in the future.
Do we need to account for current draw from a controller board as well or are they generally negligible.
If you really want my specifics I have a single 12V 350W PS, 350 12V bullets, 18ga wire.
Mahalo,
Sam


13 Replies
Posts: 9
(@cschristmas)
Active Member
Joined: 9 years ago

The general rule of thumb is 0.3 watts per pixel at full white brightness... multiply that by number of pixels and voltage to get the required watts at max load... and then factor in about 20% more for overhead and controller power...

There are other factors that apply.. but that should get you in the ballpark/a basic understanding of it

Sent from my SM-G975U using Tapatalk


Reply
Posts: 344
 TSL
(@tsl)
Reputable Member
Joined: 10 years ago

Yes power does correlate to brightness. The controller itself draws minimal power if not powering pixels through it. As for 350 pixels the power supply should do that. You’re getting close if 12v. But are all 350 hooked together in a string or multiple strings equaling 350. That will make a difference on how you approach it.

Sent from my iPhone using Tapatalk


Reply
Posts: 693
(@davdue)
Prominent Member
Joined: 19 years ago

From a purely electrical design standpoint. You would calculate the power supply capacity as follows:

Current (amps) = Power (watts) / Voltage

350/12 = 29.17 amps

So assuming you have typical pixels like DIYLEDExpress sells then each pixel will draw 50mA at full brightness and white color. 50mA = 0.05A

So for 10% spare capacity

29.17*0.9/0.05 = 525 pixels

Find out the current draw of your pixels and you can make these calculations for your installation.

Lot of people will go for 20% spare. I typically keep my pixels at 70-80% brightness so that gives more safety margin.

Sent from my iPhone using Tapatalk


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I use 20% and I use 0.06a / pixel


Reply
Page 1 / 3
Share: