Power Injection que...
 
Notifications
Clear all

Power Injection question

9 Posts
6 Users
0 Reactions
2,674 Views
rjchu
Posts: 1191
(@rjchu)
Noble Member
Joined: 17 years ago

Ditto here. And a quick test of 30 feet or so and 3 string equally spaced on it showed nice results.

Thanks,

-joni-

timon wrote:If the parallel cable is connected to each end of the string you won't need as large a cable as you would is you only connect it to the beginning of each string. I'm making injectors for my show that does just that.

Reply
Posts: 47
(@billmaxpowers)
Trusted Member
Joined: 16 years ago
timon wrote:If the parallel cable is connected to each end of the string you won't need as large a cable as you would is you only connect it to the beginning of each string. I'm making injectors for my show that does just that.

OK, just so I am understanding this correctly, when you talk about running a parallel cable, it is wired like this:

String 1 is connected to the E6804 (DATA, 5v+, Ground)
String 2 is connected to String 1 (DATA, 5v+, Ground) and Parallel cable (5v+, Ground) from power supply (5v+, 5v-)

or like this:

String 1 is connected to the E6804 (DATA, 5v+, Ground)
String 2 is connected to String 1 (DATA) and Parallel cable (5v+, Ground) from power supply (5v+, 5v-)

Just tiring to wrap my head around power injection.

Thanks


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

String 1 is connected to the E6804 (DATA, 5v+, Ground)
String 2 is connected to String 1 (DATA, 5v+, Ground) and Parallel cable (5v+, Ground) from power supply (5v+, 5v-)
[MEM] This will cause ground and power loops and make you sensitive to line noise

or like this:

String 1 is connected to the E6804 (DATA, 5v+, Ground)
String 2 is connected to String 1 (DATA) and Parallel cable (5v+, Ground) from power supply (5v+, 5v-)

[MEM] This is the correct way to inject power.

Martin


Reply
timon
Posts: 2149
(@timon)
Noble Member
Joined: 16 years ago

This is the basic idea. How many pixels you have on each power supply depends on the supply and wiring and it also depends on your topography. With my injectors and large AWG Landscape lighting cable I can power quite a large number.

In my case I'm using an RS485 Pixel Receiver/Isolator/Power Injector at the start of each run of pixels. Follow my thread here. These isolate the controller from the pixels so there are no chances of common mode voltages or noise to gum up the works. The E682 powers one side of the RS485 Pixel Receiver/Isolator/Power Injector and the pixel power supplies are connected to the other side of the it


Reply
Page 2 / 2
Share: