Notifications
Clear all

Power injection

9 Posts
5 Users
0 Reactions
3,009 Views
Posts: 84
Topic starter
(@jed42)
Estimable Member
Joined: 12 years ago
[#45411]

Ok, what is the max number of pixel people are pushing before they are power injecting? I know you should do it after 100 pixels.

TIA
:biggrin2:
Jed


8 Replies
StickyWicket
Posts: 548
(@stickywicket)
Honorable Member
Joined: 14 years ago

I think the bottom line when it comes to this question is you just need to test it with the wire/pixels you are specifically using. What looks okay to you may not to another person when it comes to pink towards the end of the string.


Reply
Posts: 485
(@jerry-rigs)
Honorable Member
Joined: 11 years ago

For strips, I don't remember seeing a consensus.
For bullet or square pixels, the rule of thumb seems to be 100 for 12v and 50 for 5v.
But then you can cut your intensity in half with little or no reduction in output and maybe get longer runs.
StickyWicket's bottom line is right. Your mileage -will- vary.


Reply
Posts: 401
(@kensington)
Reputable Member
Joined: 11 years ago

I could reliably push 110 bullets 12v on full white at 100% brightness. Things got flaky on full white after that point, although single colors could be pushed up to about 120. I inject at the front of the strand, every 200 pixels, and at the end of the strand.


Reply
Posts: 84
Topic starter
(@jed42)
Estimable Member
Joined: 12 years ago
Kensington wrote:I could reliably push 110 bullets 12v on full white at 100% brightness. Things got flaky on full white after that point, although single colors could be pushed up to about 120. I inject at the front of the strand, every 200 pixels, and at the end of the strand.

Wow every two hundred. Might have to rethink my power injection points.


Reply
Page 1 / 2
Share: