Pixlite 16 problem
 
Notifications
Clear all

Pixlite 16 problem

4 Posts
3 Users
0 Reactions
2,075 Views
Posts: 39
Topic starter
(@robomello)
Eminent Member
Joined: 12 years ago
[#34359]

I have a couple of problems with my 2 Pixlite 16.

For some reason I can't use universe 10, I already moved from Port 10 to 6 and won't work. But universe 6 works on ports 6 and 10. So I have to use universe 6. Port 10, universe 10 won't output at all.

Other problem, I have 5 trees with 20 pixels each. I placed all in series. Total of 100 pixels. It will only work up to pixel 22, after that nothing. I have another output with 64 pixels and all the pixels work. So I took this output and I tried to fire at least 64 of the 100 pixels on my trees, but it won't work either.

Other problem is with strips, on a window I have 23x12 pixels, total 70. It will work for 10min or so, after that more than half of the pixels stop working, either they freeze up, or won't turn on.

Last one, I have 4 arches that worked for 5 days with no problems, tonight arches 3 and 4 stopped working, I can see that on arch 3 it start controlling with no problem but also freezes up. If I connect on arch 3. It works with no problem.

I am not sure where the problem is.

Keep in mind that the lights won't work on the Pixlite test mode either. So is not Xlights problem.

Thank you all for the help.

Roberto Mello


3 Replies
Posts: 52
(@goofytruax)
Trusted Member
Joined: 12 years ago

sounds like you had some wires come off if the test mode won't light them.


Reply
Posts: 39
Topic starter
(@robomello)
Eminent Member
Joined: 12 years ago

On the CoroTrees, the 1st one will work, on the 2nd one only Pixels 1 and 2 work, now if I make the 2nd CoroTree be the start of the line, it will work. The universe is configured to 100 pixels and the custom model was configured correct also.

On the window frame the pixels stop working on the the middle of the strip, no wires.

The Arches now I have 2 universes, 1 for Arch 1 and 2 and 1 for 3 and 4.

All the CoroTrees have a separate universe for it.

Any ideas?

Thanks


Reply
Posts: 230
(@rtrip9)
Reputable Member
Joined: 13 years ago

That's what I did on my arches 2 universe. Now for your other issue. Sounds like the same issue I had with my mini coro trees. Data was not getting past tree 8. So I broke the 12 trees in half 6 on 1 output and 6 on another. With power injection on the last tree on each output. Works great now.

Now for output 10. Not sure as to what it going on.
Check the set up settings.
Check network config.
Plug in a (known good string) and check power
Unplug a arch and set output 10 to that universe in settings and see if it will oit put given universe data.


Reply
Share: