Pixels per port per...
 
Notifications
Clear all

Pixels per port performance

7 Posts
4 Users
0 Reactions
5,484 Views
Posts: 116
Topic starter
(@coaster)
Estimable Member
Joined: 15 years ago
MartinMueller2003 wrote:If you take a string with 600 pixels and fold it in half, then perform a color change on it, you can just make out the first and last pixels have a delay. It looks like a flicker. If the string is stretched out, you cannot tell.

Next: port-to-port artifacts depend on the controller. A software based controller only outputs one or two ports at a time. An FPGA based controller outputs data on many ports concurrently. However, not all of the data arrives at the controller at the same time so there is almost always a difference between what two ports are doing. The difference is usually so small you have to work at seeing it.

Thank you Martin, this was the information I was looking for. I ended up replacing a v1 AlphaPix4 with a Falcon F4V3 and one expansion board. Some of the new pixels I got had a problem with the AlphaPix. I tested all the pixels with an ESPixelStick and they were fine. When connected to the AlphaPix first pixel on some of the strings flash red.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Sounds like the inter frame time was a bit short.


Reply
Page 2 / 2
Share: