Pixels only turning...
 
Notifications
Clear all

Pixels only turning blue

9 Posts
4 Users
0 Reactions
7,012 Views
Posts: 24
Topic starter
(@ebenne)
Eminent Member
Joined: 16 years ago
[#51371]

I'm having an issue with some Holiday Coro 2811 Pixel nodes.

After the first 5 pixels, the rest are just blue. I've tried cutting out the two pixels where the issue starts and connecting it from there as well as connecting the string from the other side with no luck. Any advice on what else to troubleshoot with this?

I tested these when I got them and there wasn't any problem until now. :er:


8 Replies
Posts: 241
(@mrdudeman)
Reputable Member
Joined: 12 years ago

are you testing them with a sequencer(vixen)
or from controller?
try test pattern from controller to rule out patching problems/software..
or we need more info how you got them setup


Reply
Posts: 740
(@ezellner)
Prominent Member
Joined: 11 years ago
ebenne wrote:I'm having an issue with some Holiday Coro 2811 Pixel nodes.

After the first 5 pixels, the rest are just blue. I've tried cutting out the two pixels where the issue starts and connecting it from there as well as connecting the string from the other side with no luck. Any advice on what else to troubleshoot with this?

I tested these when I got them and there wasn't any problem until now. :er:

Which two pixels did you cut out? I'm assuming the last one that worked and the first that didn't work. Is that right?


Reply
Posts: 24
Topic starter
(@ebenne)
Eminent Member
Joined: 16 years ago

I'm testing them directly from the AlphaPix Flex Controller. Other strings connected to the controller are working fine


Reply
Posts: 24
Topic starter
(@ebenne)
Eminent Member
Joined: 16 years ago
ezellner wrote:Which two pixels did you cut out? I'm assuming the last one that worked and the first that didn't work. Is that right?

Yes, that's right.


Reply
Page 1 / 2
Share: