I was beginning to test a battery powered string of 100 12v 2801's, and noticed that the battery continued to drain even after I went full dark, so I put the multimeter on and found about half an amp drain (0.06 A for the controller, 0.57 with the lights too).
Wow, that's far more than I expected - about 5ma/pixel while dark. (Full on should only be about 30ma each) A second string from the same batch tested similarly.
Is this reasonable, or do I have defective strings?
Spec sheet says standby current is 1mA typ, 1.5mA max, although the conditions aren't totally specified as far as I can tell. And if they are using a regulator circuit with less than ideal standby current specs, the number you get isn't totally surprising.
If the regulator is eating 3.5 - 4ma for each pixel, that's way less than ideal.
Just modified the code to be sure it's not sending out data (in case servicing the shift registers at 1Mhz was part of the problem), and it only dropped to 0.54 A (Not much resolution on the 20A range, too high for the 400 ma range). Some of that could be the battery voltage dropping.
I'm pretty disappointed with this. I was expecting the current to drop from 3A full on to more like 100ma full off, not 540 ma.
Has anyone else tested the off current for other pixels?
Can you see through the pixel cases to see what regulator is being used (hopefully not a zener or other shunt regulator)?
It looks like a 14 pin chip on one side, some SMD stuff on the other. Kind of hard to see anything tho - makes me feel older than I am, to squint and peer so hard and still not quite make it out.
This is a bad turn. Just think a couple thousand pixels would draw a base current of 10A @ 12V even when fully off. Somehow that's not very aesthetic to me.
Now I need to measure more pixels, or get others to measure what they have. If I don't get responses on this thread I may need to start another.
