Upgrading an E681
 
Notifications
Clear all

Upgrading an E681

7 Posts
5 Users
0 Reactions
2,198 Views
Posts: 40
Topic starter
(@billytrichva)
Eminent Member
Joined: 14 years ago
[#25845]

Does anyone know what is necessary to install the wiznet in this board? It says in the instructions to contact Jim, but I haven't heard back from him. I'm not in any big rush, but I want to have what I need handy for when I am ready to upgrade it and build my new E682. I don't have a programmer, so I want to do it over the lan.

Regards,
BillyT


6 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

try this thread here >> http://doityourselfchristmas.com/forums/showthread.php?21018-E68X-Firmware-Update-via-LAN/page3

it would appear that you load the updated e681 firmware prior to swapping out the module.


Reply
intwoit2002
Posts: 412
(@intwoit2002)
Honorable Member
Joined: 18 years ago

You need to get the UPG kit from Jim which has the adapter board and the module.

His instructions are very good, but follow them exactly. I just did it on mine and worked perfect.

Good Luck


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago

Link to the upgrade instructions. Basically you download the new firmware while the old wiznet is still installed, then power down and install new wiznet module and then power up with the new module.


Reply
Posts: 40
Topic starter
(@billytrichva)
Eminent Member
Joined: 14 years ago

Already have the UPG and I have seen the instructions contained in the supplied link. Where it says "Upgrade Procedure if you do not have a Parallax Prop Plug Programmer" it states to email Jim which I have done (twice). Was hoping that someone that has done this already knew exactly what I needed to do.

Regards,
BillyT


Reply
Page 1 / 2
Share: