Notifications
Clear all

Pixels Dim Red

4 Posts
3 Users
0 Reactions
1,325 Views
Posts: 6
Topic starter
(@whalen-dan)
Active Member
Joined: 12 years ago
[#44154]

I have a tree that is being controlled by an E682 and two 360W, 30A, 12V power supplies - one for each side of the E682. Only with this tree, not any of my other house outlines or arches, do I see varying degrees of dim red pixels when the pixels are not being sent data to be any other color. When everything is off, the red is very noticeable.

The strings controlled by output banks 3 & 4 are definitely brighter. Does this have something to do with too much power coming from the power supply? How would I regulate this if so.

Thank you.

dim red pixels

3 Replies
DrNeutron
Posts: 2017
(@drneutron)
Noble Member
Joined: 14 years ago

This was a very common issue last year.
Check your voltage from each P/S and set them a little below 12V, around 11.9V or so.
There should be a small screw that will allow you to adjust the voltage.


Reply
Posts: 6
Topic starter
(@whalen-dan)
Active Member
Joined: 12 years ago

Such a simple fix. Just adjusted both PSs and it worked. Thank you for the quick help. Very much appreciated!


Reply
Posts: 28
(@vipersinu2)
Eminent Member
Joined: 10 years ago

On my tree, I have one strip that after a rain storm, it must get a slight bit of moisture inside silicone jacket and shows red dim pixels,


Reply
Share: