I have the following question.
I have two place Id like to install pixel strips (30/10 or 30/30 not sure yet) and I need the following lenghts : 14' and 5'.
I was wondering, could I order a 5 meter roll and a 1 meter, cut the 5 meter to 14' and solder the rest to the 1m?
Thanks
The strips will have cut lines with solder pads on both sides of the line. The 30/10 will only have 10 cut lines per meter and the 30/30 will have 30 cut lines per meter. Note that there are exceptions. So yes is the general answer.
From what I read though, is if I cut 12V strips.. the leds are actually only 5 volts, and Ill probably will be missing a 12v to 5v converter? Maybe I should simply get a 5v line in order to not run into this problem.
pat2k3 wrote:From what I read though, is if I cut 12V strips.. the leds are actually only 5 volts, and Ill probably will be missing a 12v to 5v converter? Maybe I should simply get a 5v line in order to not run into this problem.
This has not been my experience. 12v is 12v. Having said that, you haven't indicated what specific strips you're looking at but in general is say you should be fine.
Well, I was thinking about either 20/10 or 30/30 12V led strips. Its simply because Ive read that the 12v led strip have 5v leds in them and at every 1m or so there's a converter from 12v to 5v. Maybe maybe this was false information.
my 30/10 can be cut at every 3.875 inches
Perfect. Thanks guys, I think my best bet will be with 30/30.
Can you post the webpage of the 30/30 strip?
That is those specific pixels, not 12v pixels in general.
