Notifications
Clear all

pixel rings

7 Posts
6 Users
0 Reactions
3,189 Views
Jeff Millard
Posts: 1450
(@jeff-millard)
Noble Member
Joined: 19 years ago
Shubb wrote:Looks a lot like the sequences Brian sells for SuperStar for the LOR CCR's.
I think he has 4 or 5 videos of different songs.

Yep, same layout Dennis Cherry had built. Here's the link to Brian's page on Dennis' build.

Jeff


Reply
Posts: 1076
 Zeph
(@zeph)
Noble Member
Joined: 15 years ago

That's pretty much what I've been working towards for this year (in typical fits and stops as I have time), but using pixel strings rather than strips, mounted on pvc pipe. Here is the test rig in the back yard:

TestRig 201305

It's ugly of course, but will be taken apart before rebuilding once I have made some decisions. (And yeah, the dandelion crops needs mowing).

On the left is 6" spacing, on the right is 4" spacing. So far those folks I've used as testers have felt that the 6" spacing is very close to being as good as the 4" spacing, at less cost.

These use 20' circumference (two 10' sections of 1/2" pvc conduit). I may switch to 8' sections.

One good part about using electrical conduit is that it has built in and relatively long couplers, so I can assemble my circles without solvent, and take them apart again (I used it for hoops last year). The long couplers plus bending tension keep them pretty well attached, but by relieving the tension they can come apart again. Then I plan to store the pipe sections "flat" with lights attached (hoisted between trusses above the garage). Of course they are not really flat any more, but with tension released they are much more gently curved.

I'm still working out the connectors to use between sections. I'm considering JST SM 2.5mm connectors (3 or 4 pin depending on pixel type), but wondering how they will hold up to sun and weather. I want something which can be assembled or taken down without too much work, including setting up new arrangements, and which can be stored easily in my limited space.

The idea is to use distributed wireless controllers based on AVR + nRF24L01+, and distributed waterproof 12V power supplies. I can power 3-4 circles with one 45W power supply.

So the vision is that for setup I pound some rebar, lower the pipes from the garage overhead, bend and attach with hose clamps, plug in connectors, attach controllers (also in pvc pipe sections) and power supplies, and run AC to a few places for the power supplies, and go. I may leave the rebar in place, with solar lights on it when not using it for pixels. Then I can bring it out for multiple holidays or for parties - in various arrangements.

I'm planning for around 10-12 circles this year. Most will be beside the walkway to the house, as I don't have an open front yard - so it will be an immersive experience.

My original vision was using pixel strips. But budget considerations have caused me to start with pixel strings instead. While 6" vs 4" spacing of pixel strings doesn't make a huge difference visually so I'm going to go with the cheaper option, I think using pixel strips with 5050's would take it to another level - albeit also in terms of cost. Maybe in the future.

The other part of this is my Pixie sequencing software to control it, which I also work on in fits and starts. More on that another time. It will also be controllable via conventional sequencers of course. Maybe after dark I can take some video of the chases crossing between circles.


Reply
Page 2 / 2
Share: