E682 and WS 2811 se...
 
Notifications
Clear all

E682 and WS 2811 set-up

9 Posts
5 Users
0 Reactions
2,658 Views
dariansdad
Posts: 178
Topic starter
(@dariansdad)
Estimable Member
Joined: 15 years ago
[#25502]

I’m having a bit of trouble making sure I have this correct.

In the attached illustration, is my thinking correct? Do I “Reverse” string 1 and then “Zig Zag” every 25 pixels? There will be 5 total strings like this. A little more info here: http://doityourselfchristmas.com/forums/showthread.php?26614-Pixel-Set-up-on-E682-dilemma

Second dilemma, If I read the manual correctly for the E 682 Firmware v4.026. Can I run Dumb RGB nodes from the 682?
I want to run approximately 190 RGB Nodes for a 6 Channel Star from the same 682 as my Pixtree. I will have essentially, 800 WS2811 pixels from 8 outputs and 1 RGB Channel on each of 6 of the remaining 8 outputs.

Thanks for any thoughts.
Ron


8 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
dariansdad wrote:I’m having a bit of trouble making sure I have this correct.

Second dilemma, If I read the manual correctly for the E 682 Firmware v4.026. Can I run Dumb RGB nodes from the 682?
I want to run approximately 190 RGB Nodes for a 6 Channel Star from the same 682 as my Pixtree. I will have essentially, 800 WS2811 pixels from 8 outputs and 1 RGB Channel on each of 6 of the remaining 8 outputs.

Thanks for any thoughts.
Ron

No - the E68x cannot drive 'dumb' RGB lights - for that you need direct control of the power feeds to them versus a static power feed with a control signal as with 'smart' pixels.


Reply
Posts: 1744
(@tjetzer)
Noble Member
Joined: 18 years ago
budude wrote:No - the E68x cannot drive 'dumb' RGB lights - for that you need direct control of the power feeds to them versus a static power feed with a control signal as with 'smart' pixels.

You can run dumb RGB LEDs from a pixel controller with the addition of the Pixel DCSSR.

http://www.diyledexpress.com/index.php?main_page=product_info&cPath=13&products_id=214


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
tjetzer wrote:You can run dumb RGB LEDs from a pixel controller with the addition of the Pixel DCSSR.

http://www.diyledexpress.com/index.php?main_page=product_info&cPath=13&products_id=214

ahh yeah - forgot about those - I think the OP intent was a direct drive but yep - this will work also...


Reply
dariansdad
Posts: 178
Topic starter
(@dariansdad)
Estimable Member
Joined: 15 years ago

Thanks for the info.

tjetzer, is the build info and parts for http://www.diyledexpress.com/index.php?main_page=product_info&cPath=13&products_id=213 the same?

I just order the PCB from you and the other stuff from Mouser?
If so, you'll have another order from me shortly.

Thanks guys,
Ron

are these 1 for 1, 1 Pixel DCSSR for one set of RGB Nodes. If that's the case, I'll need 6 of these.


Reply
Page 1 / 2
Share: