Update - I was able to rejuvenate the flaky pixels by spraying some WD40 on the backs (where the wires go in). It didn't work instantly, but 24h later the 4 problem areas are all fixed (temporarily at least)
As l think is the case much of the time - water ingress is the culprit rather than the LED / driver IC going bad.
dirknerkle wrote:Don't give up on Renard and AC. It's making a comeback since pixel displays all look so similar and AC is so much more mature. I'm going on my 13th season with AC LED strings I bought from CDI back in 2010... and lots of wireless Renard...
You know Dave, I can't help but agree with you on that. It's sad when you spend the kind of money we spend on our Hobby and all it takes is a bad batch
of pixels and the fun is GONE! I went through a bag of 100 solder sleeves and a few of those 3m thingies to get through the season. Now what, throw them in the
trash and spend another thousand to replace them. It's not worth it to me, and who can guarantee the ones I buy to replace them wont end up being as bad as
the ones I just threw in the trash. Good Greif!!
I have almost 100 AC Renard Channels now and I plan on replacing the bad pixel props with AC props over the next few years.
I worked out a deal with "Falcon" a few years age to buy a Dozen or so of the Renard Plus 16 Torpedo Boards. I'm using 5 of the now and will have to get the
rest of them build here soon.
There was talk a few years back of a Re-Do of some of the Renard Plus line of boards but it never happened. I was looking forward to the possibility of a
24 channel VO chip board. With the Torpedo boards I can get 2 of them in a CG enclosure. Or, I can one in the ole 4" PVC and hang it right behind
the singing tree.
Back to simpler things. I'm going to accept PlasmaDrives challenge and see what I can come of with for AC props instead of another Pixel ...... whatever
Well something completely new tonight. I have a 99 pixel candy cane that seems to be possessed. As i was watching it it stopped responding around pixel 30 every pixel after were just random colors. About a minute later it started working again, a few minutes later it happened again at a different spot, about pixel 70. 2 minutes later off it went again working fine. I took it down and plugged it into a tester in the house and ran a chase sequence, its doing the same thing at the same locations. Bad thing is these are pixels from 2023 that I have had no problems with apart from 1 dead pixel on another candy cane. Any ideas?
thanks
Are they damp / wet? Have you tried drying them thoroughly? Sounds like water getting in to me. Try drying thoroughly plus you could try some WD40 where the wires enter. Problems coming / going can be caused by the pixel 'warming up'. Experience tells me pixels aren't always as waterproof as manufacturers would have you believe.
RichieNorthcott wrote:Are they damp / wet? Have you tried drying them thoroughly? Sounds like water getting in to me. Try drying thoroughly plus you could try some WD40 where the wires enter. Problems coming / going can be caused by the pixel 'warming up'. Experience tells me pixels aren't always as waterproof as manufacturers would have you believe.
Well if I can't trust them to be waterproof its useless trying to run a show in Florida. It hasn't rained in a few days and the crazy cane has been indoors for 24hrs, I replaced the 2 pixels I found yesterday and another 2 went crazy today, replaced them and its been running for an hour with no more problems, we'll see how it goes.
