Pixel Pop Tiny powe...
 
Notifications
Clear all

Pixel Pop Tiny power concerns

11 Posts
5 Users
0 Reactions
2,960 Views
Posts: 172
Topic starter
(@rooster519)
Reputable Member
Joined: 11 years ago
[#49461]

This year I'm introducing some Pixel Pop Tiny's into my display. I'm getting everything setup and ready to attach to the props. Has anyone had any issues running power through the board? My concern is with couple of props I'm driving 150 pixels and am unsure what controller can handle for amperage. My thought around this is to fuse the power going to the enclosure, split the positive wire when it gets into the enclosure, run one lead to the controller and the other direct to the pixel output line bypassing the controller. I would still run the ground through the board though to keep everything grounded. Hopefully that all makes sense. I am running 12 volts. Just thought I would ask so I didn't waste my time if I didn't need to.


10 Replies
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

Lets see.... 60ma per pixel. 150*.060Amps = 9 amps at 12V. *amended post* See post #6 above.


Reply
Posts: 172
Topic starter
(@rooster519)
Reputable Member
Joined: 11 years ago

I should have mentioned I run everything at 50% power. Either way way I will direct power the pixels.


Reply
Posts: 172
Topic starter
(@rooster519)
Reputable Member
Joined: 11 years ago

Sorry brightness not power. 50% brightness


Reply
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

your approach looks good to me.


Reply
Page 1 / 3
Share: