I have a batch of ws2811s from Amazon and they only work if they are daisy chained to other pixels. They don't light up attached directly to my e682.
Has anyone seen this before? 

Sent from my Pixel 2 using Tapatalk
sounds like it is on the wiring of your plugs. Check the +, Data, - on the pixel to the plugs carefully to the pinout of the plug. Its possible on the green wire ones have the a different pinout and you have crossed over the pins on the output end of your pixels that work and that is why they work daisy chained and not direct.
You need to upgrade your E682 software. The newer pixels need a longer interframe gap. Putting them at the end of another string gives them a huge gap, when directly attached to the controller they get the minimum gap allowed. Since the definition of that gap has changed, your new pixels will not work directly connected to your older software on the E682.
Thanks for the help. I'm trying to do the firmware update but the loader is throwing an unreachable network error. I've disabled all my other network devices in control panel but it persists. I emailed Jim like it says in the instructions and I'm waiting
I've also run into problems where pixels won't work with a sandevices controller if the wire between the first pixel and the controller is too short. Try adding at least a few feet of wire between the pixels and the controller. I run my sandevices controllers on a fork of the 2.x version.
I was able to update to the v5 beta of the sandevices firmware. I've tried with all values of timing from 150 to 500ns but the new lights still won't work attached directly to the controller. I'm going to try a longer run of wire next.
