Notifications
Clear all

Pixel failure

4 Posts
4 Users
0 Reactions
1,471 Views
Posts: 206
Topic starter
(@tallahassee-dreamer)
Reputable Member
Joined: 17 years ago
[#34805]

I purchased 64 strings of WS2811 pixels from Ray and upon preparing for next year (yes I've already started planning for next year) ive noticed some issues, these are in the vinyl sleeve and out of 20 strands that I have hooked up I have one string that is completely whacked, and three that each have 1 pixel not functioning correctley. These sections each are missing the red, both blue and green work fine. So my question is, do I return them?, ignore it? Or do I cut out the section and solder in a new section from the string that has over 50% failure?


3 Replies
Macrosill
Posts: 9739
(@macrosill)
Member
Joined: 20 years ago

I would be contacting him for replacements. If I buy something I expect it to work.


Reply
jaywalk101
Posts: 761
(@jaywalk101)
Prominent Member
Joined: 15 years ago

I'd burn them in a little longer and see how they hold up.. in the mean time contact Ray and see if he can send you some spares?


Reply
JP90
Posts: 376
 JP90
(@jp90)
Reputable Member
Joined: 19 years ago

I bought all my pixels from Allen Shi at Scott LED but every one says that Ray is very good at replacing bad pixels if you let him know asap. Remember one bad pixel can cause the rest to malfunction to the end if the string. If you have some pixels that are missing one color and the rest of the pixels after that are working then it more than likely is a bad 2811 IC or the LED in just those pixels and they can be cut out and replaced remember if you are going to do that that you have to watch the input and output and get them in the correct way (output to input). In any case get in touch with Ray and let him know.

Gary


Reply
Share: