Can someone enlighten on a couple of distance questions.
I am aware of power injection and understand the concepts behind it. I am just curious how much wire can be ran from controller to start of pixel string. I know that there isnt an exact number but maybe there is an average or a number to be sure and stay away from. I will be using E682 and E6802 controllers from San Devices.
Secondly, is there is max distance you can go once the pixel string starts assuming you have power injection at the proper points? For example my entire roof like will be 145 pixels at 10" apart. (holiday coro pixel bulbs). They say you can run just under 100' without power issues. So could I theoretically run all 120' or more of roof line from the same port on E682 and and just inject power at say the half way point?
If above answer is yes, if there a limitation to this? Could I run 500' and power inject where needed but continue the data signal. Obviously number of channels the port can handle is one. But I am referring to distance.
I have read in some places to only go about 20' from controller to first pixel. If this is true I would need a LOT of controllers. Probably 4. 2 for roof (left/right) and same for ground. But if you can run like 50' or 60' I could only use 2 saving me some cash for more pixels :).
no one has any experience with this? or recommendations?
To extend the cable distance try using null pixels , this would be more cost effective than adding controllers .
Yes you can run 500 in one line with power injection every 100. I have a run like that
Sent from my LG-H811 using Tapatalk
The number of pixels comes into play more than the distance for total length. It becomes a mathematical balance. The more pixels on a line the longer it takes to feed data to all of the pixels. There comes a point where you can have so many pixels on a line that the refresh rate starts to reduce your effective refresh rate. I typically say to stay below 500 pixels. But some people stretch it to 650.
For your first question the rule of thumb is that 15' or so is fine. Beyond that you need to properly condition your data line. There's several methods to do this.
--Jon Chuchla--
Sent from my iPhone using Tapatalk
