Pixel data voltage
 
Notifications
Clear all

Pixel data voltage

53 Posts
9 Users
0 Reactions
13.7 K Views
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

I don't know how to thank you enough for all your help. This is my first year and it's definitely has been a learning experience. Kinda funny because I went out to get the mail and a guy in a SUV stopped and thanked me for the light display last year. Wow! That was almost 11 months ago. Wait until he sees it this year.
I thought I wasn't going to get the display up this year. A few weeks ago I had another heart attack and they found out I have 3 abdominal aortic aneurysm's and they need to be fixed. Not sure when that's going to happen. They are looking to the stent manufacturer because they need to specially make 3 "Y" stents. Beats being open up and in the hospital for 10 days.
I have the buck converters and power supply ordered.
Again, thanks to everyone for your help.

Pat

Sent from my Nexus 7 using Tapatalk


Reply
Posts: 138
(@chris2879)
Reputable Member
Joined: 19 years ago

I ran into a similar issue using pixabulbs last year with my home built controllers. It drove me nuts! My controller was used a pic microcontroller and an ENC28j60 Ethernet device running at 3.3v. Problem is, assuming you are using a bullet with a WS2811 in it, the voltage level is CMOS, not TTL. CMOS does not guarantee a logic 1 until the voltage is greater than 3.3v, where TTL is greater than 2.0v. What was happening is logic 1 data was right around the threshold of CMOS 3.3V logic 1, and the pixels were not getting the data correctly. If the controller is not sending out 0 - 5v data signals, this potentially might be an issue operating around the logic 1 voltage threshold.

I remember reading someplace that if a jumper is removed on the E6804 the voltage level of the board is increased to around 4v, intern raising the voltage level of the data signal. I do not own one of these devices, so this might not be accurate.


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

There's only one jumper setting on the E6804 and it's only used for testing.

Sent from my Nexus 7 using Tapatalk


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

I just happened to think about something. What about the null pixels? It wouldn't make sense to put the buck converter before the nulls because that would defeat the purpose of getting correct voltage to the remaining pixels. Would it make sense to add 2 converters, one before the null pixels which would be powered by a separate line and then another converter at the end of each feed to the 50 pixel groups? That way each of the 6 pixel groups would be getting the full 5 volts. Each of the 50 pixel groups are getting a separate line from the power supply. Sorta like injection on the first 50 pixels. Did I make any sense?

Sent from my Nexus 7 using Tapatalk


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

Strike what I just said. Duh! Can't inject 12 volts after the nulls because it would blow up the null pixels even though the injection is after the nulls. Stupid me.

Sent from my Nexus 7 using Tapatalk


Reply
Page 7 / 11
Share: