Pixel data voltage
 
Notifications
Clear all

Pixel data voltage

53 Posts
9 Users
0 Reactions
13.7 K Views
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

Yikes! I just made a discovery. I was checking my Happy Holidays sign which has 480 5-volt pixels. With all the letters full white they actually weren't full white. I did one letter at a time and what a difference in whites. For right now I can live with the white being washed out. I ordered 30 more buck converters and 1 more 12 volt power supply. If I have time I can switch the sign over to 12 volts. Every day is a learning experience.

Sent from my Nexus 7 using Tapatalk


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

Mulling things over here and wonder if this will work or just a waste of time. Notice in the pic I connected the power out to the power in so that I have 5 volts going in on both sides. I haven't done it yet because I wanted a little input if it was worth trying.


Reply
Posts: 1133
(@toozie21)
Noble Member
Joined: 19 years ago
pmiller wrote:Mulling things over here and wonder if this will work or just a waste of time. Notice in the pic I connected the power out to the power in so that I have 5 volts going in on both sides. I haven't done it yet because I wanted a little input if it was worth trying.

That is what I did for my matrix, the same PS feeding both sides of the strip. Don't forget to make sure to tie your ground to the controller as well.

Short and badly typed since written from my phone...


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

I am doing it as well for my matrix (30 pixel / m strips). You run the risk of introducing noise due to power and ground loops. You will NOT hurt anything doing this. If you do get noise injection due to loops, then the pixels will appear to be unstable. That just means you need to inject every 25 pixels without loops.


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago

I just wasn't sure if it was beneficial to connect the in and out together. I'm running a 12 volt supply with buck converters to 300 5 volt bullet pixels. If I run the risk of being unstable maybe I shouldn't do it. However, you did make a point of loops. I'm running a separate negative and positive to each set of 50 pixels from the power supply. I'm wondering if I should run one negative between each group of 50 and then run the positive to each group of 50. So I would have the negative to the first group. Then run the negative from the out of the first group to the in of the second group, so on and so on. I would have less chance of any loops or noise. Does that make sense?

Sent from my Nexus 7 using Tapatalk


Reply
Page 10 / 11
Share: