I am making a spiral tree with ws2811 led strips. I have a E1.31 DIY Bridge and a Pixel Extender I want to know how many Pixels can I put on this tree? I know if I use DMX I am limited to 170. this is my first year with a Pixel Ent and have no ideal how many pixels I can use with Renard Protocol
Thanks
Tony
I don't know the limit, but I am running around 425 pixels (not channels, pixels) off 1 extender (with power injection, of course).
You mention Renard Protocol with the Extender, I think you meant WS2811?
I use WS2811 protocol and have ran up to 350 pixels (1050 channels) from one port using an extender.
I'm going to try 362 pixels this year, but haven't tested it yet.
See this thread http://doityourselfchristmas.com/forums/showthread.php?41898-DIY-LED-express-Pixel-Extender-question
posts #5-7
theoretical limit is 1665 pixels.
Holtm
Yes I am ws2811 and Thank You for the link also
If I could ask one more question how do I setup my Vixen setting to do more then 510 using E1.31
AJVenti wrote:If I could ask one more question how do I setup my Vixen setting to do more then 510 using E1.31
Type in 512 on the setup screen
WS2811 protocol can do an infinite number of pixels in a single string. The question becomes how often do you want to update the pixels. If you want smooth (video class) motion, then you need something around 30FPS. A 25ms refresh rate gets you 40 frames per second so you can get video quality transitions on your display. WS2811 at a 25ms refresh rate limits you to about 600 pixels in a string (it takes time to send the data bits to the pixels).
The next limit you will hit is the number of pixels your controller can handle. The F16V3 can handle over 1000 pixels on a single string (aka port). But if you tried to use them all, you would need to decrease your refresh rate to 50ms or higher, effectively making any video or critical transitions choppy / jerky.
well I connected 2-150 ws2811 led strip for my spiral tree then I connected 5 ws2811 pixels for the star (at end of run). I can't seem to get the star to work as I want. I was trying to make the star to work different then the led strip maybe all one color then change to another color. I can't seem to control just the 5 pixels. Can that be done? I did read the post by MartinM do I need to change the refresh rate and if so where do I change that? Also just to let you know what I have done. I first connected a 150 led strip and got it working before I added star but when I added the second 150 strip and change changed vixen controller to 160 channels. All the 300 worked at once.
Based on your reply, it sounds like they are turning on but you are not in control. Turning on is the first step. Now to get some control.
A 150 Tri-Color LED strip that is WS2811 based is usually a 3:1 arrangement. That means you only have 50 pixels in your strip with three Tri-Color LEDs attached to each WS2811 driver chip (pixel). That means you have a total of 50 + 5 pixels aka 165 channels. Is that what you have configured? Two strips and a star is 50 + 50 + 5 = 105 pixels aka 315 channels. I suspect you may have missed something in your patching.
what I love about this forum is when you go nuts thinking about a problem that you have someone has the insight to see that you counting your led strip wrong and brings you back from the edge. Thanks MartinM you rock
