Pixel controller et...
 
Notifications
Clear all

Pixel controller ethernet speed

15 Posts
7 Users
0 Reactions
5,145 Views
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I think a cheap 4-universe controller would be attractive to a lot of folks as many props can eat up that many universes pretty quick even though they are relatively small. Are you planning to provide DC distribution on it as well? What pixel types are you planning to support?


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

I'm working on a project that takes a slightly different tack. Instead of using Ethernet and E1.31, I have a PIC24F-based USB board (using a DLP USB->parallel module) that sends data out wirelessly over a nRF24L01+ module. The other end of this is a bunch of PIC16F1703 pixel controllers that receive the wireless signal, buffer the data, and control ws2801/ws2811 pixel strings. These latter controllers are about 1" x 0.6", and are intended to be cheap and small enough to be sealed and permanently attached to 50-pixel strings. This setup is targetted to supporting 16 50-pixel strings at about a 100Hz refresh rate using the Vixen2 Entec-Pro plugin. My rationale for this project is building something for myself that avoids all of the Ethernet/E1.31/Universe complications.


Reply
Posts: 459
(@shockwave)
Reputable Member
Joined: 15 years ago

At 10Mbps a full 1500 byte packet is 1.5ms to transmit. But do not forget to add in the time for moving data to the pic via SPI - that's another ms. 2.5ms is 400hz. You can throw 400 packets a second and keep up. That's unrealistic though as you have to handle the data and DO something with it. But the Ethernet won't be the slowest part. Be advised that some Ethernet modules only talk at 1mhz on SPI, meaning the module takes 12ms to transfer said packet. This is one of the jobs where you want to slam data in and out via SPI as fast as you can


Reply
jchuchla
Posts: 8698
(@jchuchla)
Illustrious Member
Joined: 15 years ago

Phil this is an interesting idea. Probably shouldn't dilute this thread too much with its discussion. I started writing a few thoughts here but it started to get lengthy so I'll just move it to a PM.

--Jon Chuchla--

Sent from my iPhone using Tapatalk


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago
jchuchla wrote:Phil this is an interesting idea. Probably shouldn't dilute this thread too much with its discussion. I started writing a few thoughts here but it started to get lengthy so I'll just move it to a PM.

--Jon Chuchla--

Sent from my iPhone using Tapatalk

Yes, I know. However this thread seemed to be somewhat general and future-looking in nature, so I didn't worry too much about thread dilution.


Reply
Page 2 / 2
Share: