Pixel connections
 
Notifications
Clear all

Pixel connections

6 Posts
5 Users
0 Reactions
1,931 Views
Posts: 9
Topic starter
(@mchedwards)
Eminent Member
Joined: 10 years ago
[#46238]

I attempted to look for a similar question as I am sure it has been made before but was not successful. I have purchased many pixels from Ray Wu for a 25 x 50 mega tree. 5V I plan to run one side off my controller, connect to second string at top and power inject at the end of the 2nd string (x12). My question is simply about the connection at the top. My pixels did come with a connector that is obviously not waterproof. I can cut them and solder together but was wondering if anyone uses large heat shrink to go over the connections. and if so, any idea what size heat shrink would fit? just thinking it would be quicker


5 Replies
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago

Are they "ST" connectors? We often will take a piece of adhesive heat shrink and use it to tie these together. No problems here.


Reply
Posts: 274
(@akareaper)
Reputable Member
Joined: 10 years ago

Finished my tree, 16X20, using 50 count strands. I just kept the JST connectors on them. I used a bit of liquid tape where the wires enter the connector, then a simple wrap of regular electrical tape around the joint, and no problems on my end. I'd be surprised if water got in, and yes, I hose tested for 20 minutes, no issues. I'm new, but I think at times we over engineer solutions. I could be wrong.


Reply
Posts: 46
(@stidrvr)
Trusted Member
Joined: 11 years ago

And here I've been cutting off my JST connectors and soldering them together. All that I have left is 8 strings for my mega tree. I might as well finish them the same. I wish I would have done this sooner.


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

Or you can add some Dielectric grease in the connection.


Reply
Posts: 274
(@akareaper)
Reputable Member
Joined: 10 years ago

Dielectric grease, better yet, just bought a couple tubes to lube connections on equipment at my farm. How did I miss that, lol.


Reply
Share: