Pixel caught on fir...
 
Notifications
Clear all

Pixel caught on fire

6 Posts
4 Users
0 Reactions
1,405 Views
Posts: 1420
Topic starter
(@1pet2-9)
Noble Member
Joined: 6 years ago
[#57271]

You see it on the news, but think it could never happen to you.

It happened to me.

It's a 12v pixel. I caught it early, because I was outside working on my megatree and smelled it. I had not touched that whole circuit in quite awhile, but...it did rain and it was wet. My suspicion is.that water snuck inside the epoxy and caused a power/ground short. I also.noticed that the connector (25 pixels down ..) on the string was very hot; I had to disconnect power and pull very hard to disconnect the connector. It's like some of the plastic on the connector melted. I power injected it from both directions--same PSU--because it's in this rectangular marquee structure (like a window pane). Fortunately, I don't think the hazard of the fire spreading was too great, because I think rain is what caused it.

My misfortune, but I can pass along the information to you.


5 Replies
Posts: 119
(@packetbob)
Estimable Member
Joined: 17 years ago

yikes...


Reply
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

This is exactly why I have all my wires with single connectors . Zero chance of shorting .


Reply
Posts: 1420
Topic starter
(@1pet2-9)
Noble Member
Joined: 6 years ago

The pixel.shorted; not the connector. It's just the current through the connector was very high. High enough to light aflame.the epoxy, but not enough to blow the fuse.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

Here is something on this topic from early last year.


Reply
Page 1 / 2
Share: