Hello all,
I've seen a bunch of the north poles on here and I remember seeing one that was all pixels that looked like it rotated almost like a barber pole. I want to make something similar only it's for a PVC fence to keep the hordes out of the yard. I've got a candy cane forest theme in the yard so I just want to do white and red on 3/4 inch PVC and have it look like it's rotating.
I'm new to pixels so before I plunk down the card I want to make sure I get the right thing.
I know I can get some standard pixels and have them stationary but to get the rotation effect can I get a pair of something like the product below set one to red and one to white and set them to "chase" or something to get this effect or would I need a more exotic controller to do this?
The product you link to are not pixels, they are dumb RGB, w/ them the whole strip can only be one color at a time, w/ Pixels, each node can be a independent color.
With the strips you link, you could get to and wrap them around the PVC in a spiral, set one to white and the other to red, then set them to alternate between red and white, assuming the controller will do that.
The rotation effect is entirely an optical effect, Nothing is moving. Whenever you have more than three rows (or in the case of a vertical element like a candy cane, columns) of pixels, you can cause a rotation effect using a sequence of lighting. More sets of pixels makes the effect even smoother.
You can do it with dumb rgb leds but use rbg+w. The illusion is because every other led is off. RGB+W has 1 white then 1 rgb and on and on.
Depending on the controller you still may need to control them using a 4 channel dmx.
MartinMueller2003 wrote:The rotation effect is entirely an optical effect, Nothing is moving. Whenever you have more than three rows (or in the case of a vertical element like a candy cane, columns) of pixels, you can cause a rotation effect using a sequence of lighting. More sets of pixels makes the effect even smoother.
So would one of these basic controllers that come with a light set like the one below be able to do the sequencing or would I need something else to get the rotation effect?
I'm using 3/4 inch PVC so I'm guessing I could only get 3 maybe 4 rows to fit.
No. That is a basic controller that assumes a single row / column and does interesting light changes. FYI: While you can get a rotating effect with Dumb RGB strip, you would have a tough time getting any sort of a spiral effect using pure vertical columns. You would need to wrap the strips around the PVC and with strips, this brings up another issue. 3/4" PVC is a pretty tight bend for 5050 LEDs being wrapped around the pipe. You may find them coming loose from the pcb. 1.5" PVC might be a bit better.
