Only Partial Pixel ...
 
Notifications
Clear all

Only Partial Pixel String will Light

22 Posts
12 Users
0 Reactions
6,107 Views
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

WS2811 is a consumptive protocol. In your test pattern, are you sure that another pixel is not throwing away some data and the end of the string is simply not being told to turn on? You can test this by placing a static pattern across the string say a fading transition where the first part of the string is green and the last part of the string is blue. Using a a 50 count string as an example:

if the first pixel does not light perfect green then the issue is in the first pixel. If after N pixels the color suddenly jumps and your last working pixel is blue then then you know a pixel has dumped the data. If the last working pixel is some color between green and blue then you know this is not the issue.

You can also run patterns over the string that can detect pixels dumping data. A group of 5 red next a group of 5 green then 5 blue then five white. Repeat. Any group that is not the correct number of pixels is suspect. Increase the size of the groups etc...


Reply
Posts: 299
(@dcamron)
Reputable Member
Joined: 10 years ago
TomL8345 wrote:Nope, I am using a 16 Universe controller from Ron's Holiday Lights. I had 2 strings of 50 running on each of 4 universes using XLights test tool. 6 of the strings were uneffected. I have tested the outputs that had the defective strings with working string successfully, so the controller is fine. The issue has to be in the strings.

Have you tried using a different output on the controller? How about the test switch on the FGPA? What daughter card are you using with the controller?


Reply
TomL8345
Posts: 1356
Topic starter
(@toml8345)
Noble Member
Joined: 15 years ago
dcamron wrote:Have you tried using a different output on the controller? How about the test switch on the FGPA? What daughter card are you using with the controller?

The same outputs are working perfectly with different strings. The issue definitely is in the strings themselves. I am just surprised that cutting out 1 or 2 pixels at the start of the problem have not fixed the issue.


Reply
JasonPortwood
Posts: 753
(@jasonportwood)
Noble Member
Joined: 17 years ago

I also use Ron's Controller. I would do the string test function on it to see if it lights all the pixels on the sting - switch in a new string to be sure too. That's the obvious first step. If other lights work then it's definitely in the string.


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago
TomL8345 wrote:The same outputs are working perfectly with different strings. The issue definitely is in the strings themselves. I am just surprised that cutting out 1 or 2 pixels at the start of the problem have not fixed the issue.

Did you try a couple pixels prior to the problem area?


Reply
Page 2 / 5
Share: