Only Partial Pixel ...
 
Notifications
Clear all

Only Partial Pixel String will Light

22 Posts
12 Users
0 Reactions
6,106 Views
TomL8345
Posts: 1356
Topic starter
(@toml8345)
Noble Member
Joined: 15 years ago
[#45423]

I am in the process of burning in the pixels I received from this year's PreSale. They are the standard WS2811 12v 12mm bullet pixels. I always hook up my new strings and "burn them in" for 12-24 hours before I do anything else with them to try to find bad pixels. While I was doing this today we had the power go out suddenly. Every time I had checked on the pixels before hand all was well (a couple of bad pixels), but after the power came back on two of the strings were only partially lit. I figured I had a bad pixel, so I cut out the 1st pixel that was not working in the string and spliced it back together. No change, the second portion of the string would still not light. I then thought the problem must be in the the last pixel that did light, so I cut that out as well and spliced the string back together, still no change. I have put my voltmeter on the end of the string that is not lighting, and still getting 12v, so I know the issue must be in the data line.

I am looking for suggestions on what I should do next to troubleshoot these strings.

Also is it possible that the power failure is to blame for the issues I am now having? My computer, PS, and controller all came through without an issue.


21 Replies
Posts: 128
(@emuney18)
Estimable Member
Joined: 11 years ago

Is it possible you are using a Falcon and the power outage reset the pixel number to the default 50 and you are using 100 node strings?

Sent from my iPhone using Tapatalk


Reply
TomL8345
Posts: 1356
Topic starter
(@toml8345)
Noble Member
Joined: 15 years ago
Emuney18 wrote:Is it possible you are using a Falcon and the power outage reset the pixel number to the default 50 and you are using 100 node strings?

Sent from my iPhone using Tapatalk

Nope, I am using a 16 Universe controller from Ron's Holiday Lights. I had 2 strings of 50 running on each of 4 universes using XLights test tool. 6 of the strings were uneffected. I have tested the outputs that had the defective strings with working string successfully, so the controller is fine. The issue has to be in the strings.


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

take a known good string and wire it into the end of the last lighting pixel and see it lights, if so you might have had more than 1 pixel in the string go bad.


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago

Or wire the "bad" part of the string directly to the controller. Does it work then?


Reply
Page 1 / 5
Share: