Odd pixel behavior
 
Notifications
Clear all

Odd pixel behavior

9 Posts
6 Users
0 Reactions
1,291 Views
Posts: 10
Topic starter
(@kmc-pyro)
Eminent Member
Joined: 9 years ago
[#56242]

So, while setting up my display, I noticed that a small number of pixels scattered throughout the display, one here one there, are acting in a strange manner. When I go to do individual pixel testing through FPP I noticed that it seems as if their RGB order is off, this hasn’t been an issue in the past, as they were functioning correctly in the prior year. It seems as if they pass data fine, because the rest of the pixels later in the chain are functioning correctly so it seems to be just that individual pixel that’s malfunctioning.

Has anyone else experienced this?

Sent from my iPhone using Tapatalk


8 Replies
Posts: 418
(@richienorthcott)
Reputable Member
Joined: 7 years ago

When you say color order is off, assume you are testing with pure Red, Green and Blue? Can you isolate it to individual LEDs or the source data by connecting a different string to the same data? Sounds odd, particularly since as you say the data recovers later on. To me it sounds like the source data might be dicky rather than hardware from what you describe, though not sure what would cause that. Assume the voltage at the affected pixels is okay?


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

Another possibility is that some pixels with a different RGB order have been spliced into the string to replace bad pixels, although I assume that you would remember doing that...


Reply
DrNeutron
Posts: 2017
(@drneutron)
Noble Member
Joined: 14 years ago

As stated above, check individual RGB colors to verify that one led is not out or weak.
I have replaced over 50 this year alone that have a Blue LED flickering or out entirely.
One easy way to spot if a pixel is missing an LED color or is weak is do a full white. If any pixel is not showing full white then replace.
This is of course assuming good PI and data.


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

What I get a lot of are broken pixels that are always-on. Black becomes red, green becomes yellow. Yellow goes white. The pixel is simply broken, and needs to be replaced. Fortunately, I can reuse the broken ones as special null pixels, because the data pass thru is fine, and they tell me I am getting power (or even better, if I am getting 12v through that 5v pixel).


Reply
Page 1 / 2
Share: