Null pixel wiring
 
Notifications
Clear all

Null pixel wiring

5 Posts
4 Users
0 Reactions
1,650 Views
tucsonlights
Posts: 667
Topic starter
(@tucsonlights)
Honorable Member
Joined: 15 years ago
[#30672]

Hi guys,
I know this might be a stupid question but, when wiring a null pixel (2811) between the controller and the start of the pixel string do you just connect the data and ground wires to the null pixel?:blush2:


4 Replies
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

You wire it in exactly as your other pixels - you need to set up your controller to use it as a null pixel. It will not be referenced in the list of pixels from your sequencer standpoint.


Reply
Posts: 389
(@jcross)
Reputable Member
Joined: 15 years ago

It does need to be powered:)

Jason C


Reply
Electrified3
Posts: 716
(@electrified3)
Prominent Member
Joined: 13 years ago

The null pixel is acting as a repeater for your data, so yes it does need to be wired the same as the rest. It receives the data signal and does not strip any data from it, just boosts the signal back up and passes the data to the next pixel to get the data the distance you require. As Brian said your controller configuration will tell it to ignore that pixel.

Just an FYI, sometimes if you use heavier gauge wire to get to your pixels you can avoid using null pixels, I have had a few 65-75' long that worked fine with no null pixels, but I did use #12AWG as an extension on them. I would suggest building your extensions first and testing them before adding in null pixels, make that your last resort. If going a very long distance sometimes it is cheaper in the end to use another controller by the time you factor in all the cost of extensions and so forth.


Reply
tucsonlights
Posts: 667
Topic starter
(@tucsonlights)
Honorable Member
Joined: 15 years ago

Thank a lot for the replies.


Reply
Share: