New System Design
 
Notifications
Clear all

New System Design

3 Posts
2 Users
0 Reactions
1,212 Views
Posts: 2
Topic starter
(@keithboylan)
New Member
Joined: 11 years ago
[#39345]

Hi I'm starting a design for a new project not done this before so I have made a list of what I think I might need in equipment but not sure of controller numbers. What is the total length the strips below can be can they be joined together this will determine my amount of controllers for outputs

Controller
Sandevice E682

LED Strips to go around house outline and Windows
Spec
5050 smd rgb led strip ws2811
Input voltage :.............DC12v;
Power: .......................14.4watt/meter, 72watt/roll;
LED resource:.............High brightness 5050 RGB;
Q'ty of LED: ...............60leds/meter, 240leds/roll, each 3LEDs separately controlled
IC Type: .....................ws2811 IC;
Q'ty of IC: ..................20IC/meter (1 IC drives 3led chip);

Thanks in advance
Keith


2 Replies
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

They typically are 5 meters a roll. Yes they can be connected using power injection. The E682 has 16 outputs so you might not need physically connect them.


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

The 60led/20 chip per meter strip is fairly common. You might buy a strip and a strip of 30led/30 chip 5volt and test them before you commit. Some people have bought 60/20 and then decided to replace them with 30/30. Not most people but more than a couple. Might save you money in the long run.


Reply
Share: