normal thought is that if something blows.... ya gotta get up there and fix the short anyway!
pmcpa wrote:normal thought is that if something blows.... ya gotta get up there and fix the short anyway!
Very true – but just thinking – up go up fix the fault (or what you think is the fault) move the ladders change the fuse – oh it blows again – so you move the ladders again – find what could be a fault repair it – move the ladders – dam no spare fuses – jump in the car, drive to the local store / garage and buy some fuses – up the ladder insert fuse.
People haven’t reported much in the way of problems with pixels blowing fuses (they simply go white or don’t do anything) so it’s probably not an issue really.
It only becomes an issue if YOU do something stupid (wires crossed) or something likes to chew!
Barnabybear wrote:Nice looking board.
Jim - any reason you went for fuses as opposed to PTCs?
A little board like this lends it's self to being stuck on ridge lines and in trees to run the 'out of the way pixels' and might not be that easy to service.
Somthing like this shouldn't cost more than a fuse and fuse holder.Just a thought.
I did look into polyfuses at one point but iirc there was an issue with the trip point varying quite a bit with temperature. Also with a soldered part it has to be pretty much a once size fits all, whereas the pluggable fuses can be sized to the particular situation.
With a typical pixel string the only time the fuse is going to pop is if there's a hard short in the wiring between controller and start of string. A short between the +V and ground wires at the end of the string won't generally blow the fuse since the current is self-limiting to less than 5 amps because of the resistance of the wire.
jstjohnz wrote:I did look into polyfuses at one point but iirc there was an issue with the trip point varying quite a bit with temperature. Also with a soldered part it has to be pretty much a once size fits all, whereas the pluggable fuses can be sized to the particular situation.With a typical pixel string the only time the fuse is going to pop is if there's a hard short in the wiring between controller and start of string. A short between the +V and ground wires at the end of the string won't generally blow the fuse since the current is self-limiting to less than 5 amps because of the resistance of the wire.
Thanks for the incite.
Temperature adds an uncontrollable variable, and as you stated the PTC are not as easily swapped dependant on your string length.
So – fuses are cool.
Thanks for the reply – and we look forward to your next post.
Thanks phil.
