I am kicking around the idea of building a Radio-Frequency Sign, probably around 36" (tall) x 48" (wide) with pixels
so it would not only display the frequency, but could be used for other information or effects. Is there a feasible way to do this
without breaking the bank !! Also, I am using three Renard SS24's and four Renard SS16's and Vixen 2.1. Can it be controlled
with what I have or will I need to update my version of Vixen? Will Vixen run both the regular show and the Pixels. I know basically
nothing about Pixels, so I thought I would start small. Any suggestions or advice would be appreciated and will be more than I know now !!
Thanks !!
What's your definition of 'breaking the bank'?
If you are planning to use pixels on this sign, then none of your current hardware is suitable to drive those pixels. You need a "pixel" controller, since pixels are intelligent and require something that talks "pixel" language to them. All your Renards just drive AC based lights.
However, that doesn't mean you need to move away from your current software, Vixen. It's possible to talk to the pixel controllers from Vixen, but it's not always the easiest thing to do. It gets way more complicated with pixels, since each pixel is 3 channels (Red, Green, and Blue). You might want to check out the wiki, since there is some info there about pixels, how they work, and what kinds of controllers.
Suffice it to say, you'll need that pixel controller (perhaps several, depending on how many pixels). You have several choices, including SANdevices E68x series, j1sys P12 or P8 series, Pixelnet (there's a member here working on a controller), or even a commercial version, such as the Stellascapes line.
You may need to upgrade your show computer too, since with lots of channels comes the need for more processing power.
That's a good starting point - keep asking questions...of course, all this requires the purchase of pixels, too, which can "break the bank" if you think that each pixel is about $.40-.50 each...
Alot of us order pixels from China, and you can go at .20 cents a pixel, but shipping can be a bit pricey. Had I not just ordered last week, I would've let you piggy back the order to reduce shipping costs.
Depending on the number of pixels, will determine how expensive of a controller you might need. The pixel controllers can range in price from assembled to DIY. I'm not much on soldering of small things so I bought 4 assembled E682's from Sandevices. 180 a pop, but DIY would have been about 110 if I recall, plus you need a power source, and an enclosure. Each of which, on the cheap end are 20 bucks a piece, if you by a Mean Well, which is a good power source, probably looking at 50-70 for that.
So yeah, P short asked the right question...whats your definition of breaking the bank!
I may be in the minority here, but I think even at this advanced stage of pixels, if I wanted a digital sign, I'd still build an LEDTriks.
Chris at WLC Ventures carries kits for the two controller boards (LEDTriks and Triks-C) needed ... a quick visit to eBay and you've got the LEDs ... at 36-inches by 48-inches worth of space, you could do a 1 x 4 layout (or 2 x 2) that would be pretty nice.
Doing the LEDs on pegboard, a 1 x 4 would run you less than $300 for the LEDs and the controllers ...
The sign itself is controlled by a small .exe that can run in the background behind Vixen and consumes only a tiny amount of resources, so it wouldn't impact your show computer.
Even with the cheapest pixels, a similar sign would run somewheres north of $1250, not counting the controller or the (probable) need for a new show machine.
HTH.
\dmc
