I am new to the world of pixels and I am trying to get my E682 to connect (automatically?) directly (and in static mode) to my computer. I built the E682, went through the power up sequence, finished the build, connected a string of 25 GECE lights to 2-1 as instructed, powered up and got the default sequence built into the controller.
I then plugged in the E682 to my computer and typed in the address 192.168.1.206 and it timed out. I then followed the instructions to force the controller to DHCP (169.254.74.73) and was able to connect to the device (Failed?). With a lot of help from Jim, I was able to change the IP address of the E682 to 192.168.105.206, saved, and tried to reconnect. Timed out again.
How can I configure the E682 to connect in static mode (and again, is there some sort of auto function) to my computer? I am not hooked up to a network of any kind.
I am running a Dell I3 laptop, Windows 7, 64 bit machine. The WLan is disabled as not to interfere, and I am running Firefox as the browser.
I think the ".105" is odd, but it seems to be common on some machines.
A screen shot is attached.
Thanks for your help.
Hi Keith,
If you will be using a direct connection, E682 to PC, you want to set a permanent IP address on the E682 of 169.254.74.73, and connect using that address. If you will be attaching the E682 to your router, you would then use the 192.168.1.206 address.
The IP on your PC's NIC has to be in the same subnet as your contoller. So if you want to use the 192.168.1 range then you need to statically assign your nic with something like 192.168.1.5 with a subnet mask of 255.255.255.0 There is no need to set the gateway are DNS addresses. Once you hit apply you will be able to hit the web interface of the controller.

