My lights won't act...
 
Notifications
Clear all

My lights won't activate

7 Posts
6 Users
0 Reactions
2,060 Views
Posts: 126
Topic starter
(@thechief96)
Estimable Member
Joined: 11 years ago
[#43034]

I am trying to run a short animated sequence to check my system. I can get the lights to turn on when I place my F16v2 into a test mode, however when I try to get them to turn on from x-lights I get nothing. I turn on the light bulb. I have my network set to say 10.10.10.1 and my falcon to 10.10.10.3 as well as the ports on unicast set to 10.10.10.3. When I go to the tools/check sequence tab I get this message: IP Address we are outputing data from: 10.10.10.1.Any ideas if this is wrong or right?


6 Replies
Posts: 825
 DanJ
(@danj)
Prominent Member
Joined: 13 years ago

You might want to post over at the xlights and/or Falcon forums too. I don't think there is an issue with your setup, but it would be good for some more experienced Falcon/xlights people to weigh-in here. Make sure your channels in xlights match with your channels on your F16 in regards to universes/channels and that xlights and Falcon both have the same unicast info on them. I have goofed that up on my E682 before and it doesn't work if you don't have all the pieces just right! Also, don't forget to select the channels you want to test (or maybe just select all) in the xlights test panel popup. I have forgotten that before...


Reply
Posts: 1592
(@ruppro)
Noble Member
Joined: 11 years ago
thechief96 wrote:I am trying to run a short animated sequence to check my system. I can get the lights to turn on when I place my F16v2 into a test mode, however when I try to get them to turn on from x-lights I get nothing. I turn on the light bulb. I have my network set to say 10.10.10.1 and my falcon to 10.10.10.3 as well as the ports on unicast set to 10.10.10.3. When I go to the tools/check sequence tab I get this message: IP Address we are outputing data from: 10.10.10.1.Any ideas if this is wrong or right?

Post screenshots of your xlight, falcon, and PC network setup pages, easier to see what may be the issue.


Reply
Posts: 126
Topic starter
(@thechief96)
Estimable Member
Joined: 11 years ago

Just spent some time with David Pitts. He walked me through everything and I am up and running. That is customer service.:thup2:


Reply
Posts: 1049
(@phrog30)
Noble Member
Joined: 12 years ago

I'm glad you decided to remove your controller for all to see, I hope you understand why that is a bad idea.

David Pitts is a great asset to the community. He has helped a lot of people. I would post your findings on your problem, perhaps it will help someone else.

James

Sent from my Pixel using Tapatalk


Reply
Posts: 236
(@afremont)
Reputable Member
Joined: 10 years ago

I had a similar problem. Finally, I figured out that I had to click the light bulb icon to enable them to actually light. I'm kinda dumb like that.

Sent from my Moto G (4) using Tapatalk


Reply
dpitts
Posts: 1020
(@dpitts)
Noble Member
Joined: 16 years ago

The OP now has a better understanding of channel mapping which was the source of his dilemma.

Sent from my LGLS992 using Tapatalk


Reply
Share: