Mega tree controlle...
 
Notifications
Clear all

Mega tree controller

14 Posts
5 Users
0 Reactions
5,077 Views
Posts: 825
 DanJ
(@danj)
Prominent Member
Joined: 13 years ago

I'm going the non-power injection direction this year. Trying to power up single components (e.g., megatree strands, minitree, etc...) off of single outputs of my F16s and expansion boards.


Reply
Posts: 431
Topic starter
(@dkelly0802)
Honorable Member
Joined: 11 years ago

Doug I'm trying to picture your setup. I understand the data but confused about power and ground. Did you pigtail 8 strings together for each channel at the bottom and run a single line to the controller?


Reply
Posts: 431
Topic starter
(@dkelly0802)
Honorable Member
Joined: 11 years ago

I'm trying to set this tree up with what I have. I would love to get a falcon but could use the money in better ways at this time. I am still open for suggestions I like reading how everyone else sets up they're props. Thanks


Reply
Posts: 347
(@dougd)
Reputable Member
Joined: 19 years ago

I use 2 pin water proof connectors. I then use 14 gauge wire. Spacing on my tree is 8 inches. I then put one side on the water proof connector every 8 inches on the 14 gauge wire. I will power 8 strings that way. One end ties to my power supply Plus and the other side to ground. Then data from the controller goes to the first string and I tie the ground from the controller anywhere on the ground side of the cable that I made. I then jumper data at the top of the first string to the second string, then at the bottom between string 2 and 3 and so on. Hope that helps, If not when I get home I can send some pictures.


Reply
Posts: 431
Topic starter
(@dkelly0802)
Honorable Member
Joined: 11 years ago

It's a lot clearer now but would really appreciate the pictures. Thanks for all your help.


Reply
Page 2 / 3
Share: