Matrix stopped work...
 
Notifications
Clear all

Matrix stopped working

3 Posts
2 Users
0 Reactions
1,151 Views
Posts: 79
Topic starter
(@blackramair)
Estimable Member
Joined: 12 years ago
[#39969]

So I have a 16x32 matrix. They are all 12v bullets it has been running flawlessly until just about an hour ago. The back half of the matrix stopped working. Stopped the show and put controller in test mode only half light up. My last pixel to lite is about 10 nodes from my power injection point. I ran these at 128 nodes per power injection. This has been running fine since Thanksgiving. I'm thinking I need to move my power injection closer together. This is my first year and have had multiple problems the wife is really upset with me and saying this isn't worth the trouble. I disagree but it is frustrating. Any thoughts on something I may be missing.
Thanks


2 Replies
Posts: 6
(@cgladue)
Active Member
Joined: 11 years ago

water get into the first pixel that isnt working ? what if you replaced that pixel or tied in another string right before it ?


Reply
Posts: 79
Topic starter
(@blackramair)
Estimable Member
Joined: 12 years ago

I will be working to repair this Saturday. I don't get home from work till 7p.m. doesn't leave any time to be trying to solder outside. It did rain the other day a little but it worked that night and last night. I will check also, I had planned on bringing a small dmx controller outside cutting at my injection points and testing each string of 128 to see if the work that way. Then work connecting one string at a time till I get them all working again. When I went out the second half was stuck with red lettering I presume it stopped during a scrolling text portion of the show.


Reply
Share: