matching 5m address...
 
Notifications
Clear all

matching 5m addressable rolls?

4 Posts
3 Users
0 Reactions
3,760 Views
Posts: 5
Topic starter
(@indynick)
Active Member
Joined: 8 years ago
[#52685]

Hey gang. So I have a project I'm working on. I have 2 rolls of addressable strips and a controller. The problem I'm running into is the blue and green are opposite from each strip. If I pick green 1 roll will show green and the other will show blue. So I'm getting different effects/ colors. Red is fine on both strands if that makes a difference.


3 Replies
Posts: 8517
(@angus40)
Illustrious Member
Joined: 15 years ago

It sounds like the color order of the incorrect roll should be set to RBG assuming the correct strip is set to RGB .


Reply
scottmcm
Posts: 621
(@scottmcm)
Prominent Member
Joined: 19 years ago
IndyNick wrote:Hey gang. So I have a project I'm working on. I have 2 rolls of addressable strips and a controller. The problem I'm running into is the blue and green are opposite from each strip. If I pick green 1 roll will show green and the other will show blue. So I'm getting different effects/ colors. Red is fine on both strands if that makes a difference.

I ran into the same problem with some of my strips. You just have to go into the color setup for those pixels in your controller software (Vixen in my case) and reverse the offending colors.


Reply
scottmcm
Posts: 621
(@scottmcm)
Prominent Member
Joined: 19 years ago

They are on the same controller, a PX1 in this case. I just have the color handling of pixels 1-50 defined as RGB and 51-100 as RBG for example.


Reply
Share: