Hi guys,
Apologies if this has already been asked, have searched but couldn't find anything.
I'm looking at using the 16port Experience Lights controller, with a 4 port long range controller. This is designed to have a ethernet cable between the two by design.
My question is - what protocol is used for this long-range link? Reason I ask, is I'd like to know if it's possible to put a ethernet-->fibre convertor at one end, and fibre-->ethernet at the other. This is designed to avoid electrical issues, lightning protection etc (long story).
So just curious if anyone has any knowledge here?
Thanks in advance!
jordang wrote:Hi guys,Apologies if this has already been asked, have searched but couldn't find anything.
I'm looking at using the 16port Experience Lights controller, with a 4 port long range controller. This is designed to have a ethernet cable between the two by design.
My question is - what protocol is used for this long-range link? Reason I ask, is I'd like to know if it's possible to put a ethernet-->fibre convertor at one end, and fibre-->ethernet at the other. This is designed to avoid electrical issues, lightning protection etc (long story).
So just curious if anyone has any knowledge here?
Thanks in advance!
The output is serial Protocol not ethernet Protocol.
there's is a serial to fiber then fiber to serial Adapters.
Sent from my SM-G970U using Tapatalk
JerryPlak wrote:The output is serial Protocol not ethernet Protocol.there's is a serial to fiber then fiber to serial Adapters.
Sent from my SM-G970U using Tapatalk
Perhaps one of the designers can chime in, but I have had links from the Genius controller to a Smart Receiver over 200 feet. If it is a serial protocol, in theory it is possible to get up to 4000 feet with RS485.
Thanks for your help guys - I also received this back from David at Experience Lights (within an hour! Must admit I asked in here because i never thought I'd get a response from the website contact page. 🙂 )
"These communicate using an RS485 signal, not ethernet. This is the same protocol that is used by all pixel board manufacturers presently, so you wouldn't be able to use ethernet related products on those lines. "
While it most likely wouldn't help with a lightning strike the Advatek Long Range Isolated Receiver ( https://www.advateklights.com/isolated-receiver ) is isolated. It has 4 seperate RS-485 inputs each with an opto isolator to isolate it from the Pixel driver outputs (along with an isolated power supply to drive the RS-485 receivers). Not sure if any other receiver designs include such isolation. I have used the Advatek receivers with the PixLite LR controller and the SansDevices E682.
