limiting factor for...
 
Notifications
Clear all

limiting factor for first pixel?

8 Posts
7 Users
0 Reactions
2,379 Views
Posts: 277
Topic starter
(@blake-l)
Reputable Member
Joined: 19 years ago
[#35467]

Like the title says: what's the limiting factor(s) for the distance to the first pixel? All I can think of is power loss or data degradation.

I currently have (1) E682 - trying to figure out how to best locate it, but still be able to have pixels where I want them. Most of my strings will be 50 or less, so was planning on doing them all as home runs - maybe that's just a holdover from what I'm used to with a Ren64, but I'm also hoping it will cut down on the need for power injection.


7 Replies
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

What type of pixels are you using?


Reply
jklingert
Posts: 1767
(@jklingert)
Noble Member
Joined: 16 years ago

A typical 2811 pixel is good for about 25 ft before the data signal degrades, but you can always use null pixels to go further. The bigger issue is voltage drop over long power leads. There is info in the wiki on both issues.


Reply
Posts: 212
(@myoung84)
Reputable Member
Joined: 12 years ago

I had one string of 100 2811 pixels that where on a 40' cable without null pixels. At times I had slight flickering with full white but that was the only time. All my effects worked perfectly. It was really just a test to see if it would work and I planned on adding a null pixel but never did. This was using 18/4 copper cable from the controller to the pixels.

My next longest run was about 30' but I added a null pixel in the middle since it was on the roof and didn't want problems.


Reply
Posts: 389
(@jcross)
Reputable Member
Joined: 15 years ago

You could also use a Pixel Extender with a E1.31 bridge.


Reply
Page 1 / 2
Share: