Notifications
Clear all

Lights

13 Posts
4 Users
0 Reactions
3,337 Views
Posts: 283
Topic starter
(@lamar-bolen)
Reputable Member
Joined: 9 years ago
[#46037]

Hello I have 2 arches the first arch works good the second I hooked up to the first with the connectors that just snap together and it comes on but it doesn't change color can someone please help me

Sent from my SM-N910T using Tapatalk


12 Replies
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Lamar, you should really put a picture of the connector that you are talking about. I would bet any amount that your connector is the reason, but without seeing it, it would still be a guess. My advice is to ask more specific questions with more detail, rather than generic questions like you have been asking. Almost everyone solders connectors to strips instead of using the snap on type.


Reply
Posts: 283
Topic starter
(@lamar-bolen)
Reputable Member
Joined: 9 years ago

Here is the connecter

Sent from my SM-N910T using Tapatalk


Reply
Posts: 2048
(@scootchu)
Noble Member
Joined: 17 years ago

Is that another red wire up top? Lamar, no offense, but you have to put a little effort in on your part to enable people to help you. Your first string should have Data, V+ and V-. You can try to pass Data, V+ and V- to the next strip and see if you can get away without having to add power injection to the second strip. I can't make out what you have going on with you connection there.
Oh and what controller? You may not have it set for the right number of pixels. You make have it set for 50, when it's 100. In that case the first 50 would respond, but the next 50 wouldn't


Reply
Posts: 283
Topic starter
(@lamar-bolen)
Reputable Member
Joined: 9 years ago

It's just the blue wire for the ground white for the data and the red for power the other wires is just a extra power and ground

Sent from my SM-N910T using Tapatalk


Reply
Page 1 / 3
Share: