Hi gurus
I have started setting up xlights and have laid out my models and the pixel numbers etc, taken my time to get it all correct. There don't seem to be any overlaps etc
I tried to upload outputs from xlights to the fpp and when I went to the controller outputs page on fpp it had only added the first 3 models so there over a dozen missing.
Does anyone know why they wouldn't have been sent across?
My edup wireless is setup and all functioning, the kulp board has a static up address and all that is functioning well.
When I switch xlights to output direct to the controller the first 3 outputs are responding properly but none of the rest are.
Is there an easy way to set them up in fpp so there are no conflicts and they both match?
Or should I try uninstsllomf and reinstalling fpp?
Can you send a pic of your xlights set up page? I have a k8b and no issues uploading any model changes. I'll try to help if I can.
Hi
I am getting there I believe. I think I had clicked the auto size button so it was only displaying 512 channels.
I have now got them to all show. It's a reasonable learning curve but I am slowing getting to grips with it.
When modeling a tree for instance if you say it's 16 strings of 50 nodes then it adds 16 outputs instead of one.
The only way around that seems to be to model it as 2 strings each of 200 with 2 strands each but then it displays strangely.
I think I will have to model it so it "looks right" in xlights and upload it so the data is all there and then manually configure the fpp channels somehow.
Thanks for the offer of help.

