KULP K16A-B only li...
 
Notifications
Clear all

KULP K16A-B only lighting half the string

5 Posts
5 Users
0 Reactions
1,752 Views
Posts: 15
Topic starter
(@joeyw1986)
Eminent Member
Joined: 6 years ago
[#54794]

I got a new Kulp K16A-B board for this year. In testing my pixels for some reason whether using the test function through the board itself or through FPP the test only lights half the string of lights stopping at exactly 50. I have looked and cant see any settings that would cause this. I checked that it was going through the full channels (1-300) and not stopping early as well as setting up inputs and outputs. No luck. I then hooked them up to my old Sandevices E682 and they worked great all lights working.

Any advice or tips given would be greatly appreciated

Thanks Joey


4 Replies
Posts: 242
(@rsegreto)
Reputable Member
Joined: 6 years ago

It sounds like the controller output is setup for only 50 pixels. Check the settings in Xlights for that port or through the outputs in FPP.

Sent from my iPhone using Tapatalk


Reply
Posts: 13
(@bbeachyak)
Eminent Member
Joined: 5 years ago

I am having this exact same issue!! In FPP I looked through all the options for the test and just like you said had every channel for the test sequence, but I could only get 50 pixels (1 string) to illuminate. The same thing happens when I use the test button on the kulp board. I guess I need to finish a sequence for my show in xLights and test it that way, but any help would be greatly appreciated!


Reply
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Look at your output screen for FPP
- Input/Output Setup
- - Channel Outputs
- - - K16-A


Reply
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago

I played around with that. When you run diagnostics, it seems you have to set up 150 channels per string--not 50. If I have 150 channels, in groups of 1, then 50 RGB pixels will work.


Reply
Share: