Notifications
Clear all

Kulp F8

10 Posts
4 Users
0 Reactions
1,872 Views
Posts: 409
Topic starter
(@dim-bulb)
Reputable Member
Joined: 9 years ago
[#54790]

I currently run 2 Falcon F16v3's in my show. I love having the Pixelsticks on my show, however i hate having to try and access 10 different sticks, plus for some reason when it gets cold and foggy here, my wireless signal goes to hell and router freezes up. looking to do away with it and just use a Ethernet hub. Seeing as how Falcon has no 8 output controller, i am looking at the Kulp F8. I can put one on the roof for the roof lights an props then another on house face to run the all the props there. I see they run off a BBB, but can i just run a Ethernet cable to them like i do my F16's and have them controlled from my main Raspberry PI?


9 Replies
Posts: 2507
(@mrgrumpy)
Famed Member
Joined: 12 years ago

Yes from F*-B (or PB) to a Ethernet switch or router. Not familiar with a Ethernet Hub
Look at the F8-PB too. WiredWatts.com has in stock


Reply
Posts: 409
Topic starter
(@dim-bulb)
Reputable Member
Joined: 9 years ago
mrGrumpy wrote:Yes from F*-B (or PB) to a Ethernet switch or router. Not familiar with a Ethernet Hub
Look at the F8-PB too. WiredWatts.com has in stock

Sounds like the way to go then. Thought about another F16, but did not want 8 long cords going up the front of my house to the roof.


Reply
Posts: 3735
(@algerdes)
Famed Member
Joined: 15 years ago
mrGrumpy wrote:Yes from F*-B (or PB) to a Ethernet switch or router. Not familiar with a Ethernet Hub
Look at the F8-PB too. WiredWatts.com has in stock

FYI - Just in case you didn't know - the "hub" was a pre-cursor to switches. By today's standard, it is "dumb". All ports received all signals for all other ports. The term, "hub", still is used by some of us "old timers", but I haven't seen a "hub" offered for sale for some time now.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
algerdes wrote:FYI - Just in case you didn't know - the "hub" was a pre-cursor to switches. By today's standard, it is "dumb". All ports received all signals for all other ports. The term, "hub", still is used by some of us "old timers", but I haven't seen a "hub" offered for sale for some time now.

I think it has been over 20 years since a true Ethernet Hub has been sold (still have a 4 port for testing). Everything since then has been zero config (dumb) switches (ok I'll give them semi-smart status) that work fairly well.


Reply
Page 1 / 2
Share: