kulp controllers an...
 
Notifications
Clear all

kulp controllers and remote nodes

3 Posts
2 Users
0 Reactions
1,508 Views
Posts: 59
Topic starter
(@pyro2k)
Trusted Member
Joined: 5 years ago
[#55586]

Hi if I were to procure something like a kulp k8-b which has connections for a differential controller nodes via ethernet, does the differential node just look like more strings off the main controller? I am trying to determine how the remote node would look from something like the FPP software running on the primary controller.

Am I safe to assume that I can run this up to 100m away from the main controller via normal cat6 cables? I don't think I would be anywhere close that but wanted to check before I jump in.

For reference this is the k8-b: https://kulplights.com/product/k8-b/

and this is the remote node: https://www.pixelcontroller.com/store/expansion-boards-and-receivers/56-4-string-differential-receiver-board.html

Is the primary benefit of using a differential controller the ability to run farther distance?

I was also looking at the expansion controller which seems to offer a similar ability but must next to the primary controller.

Expansion controller for reference: https://www.pixelcontroller.com/store/expansion-boards-and-receivers/40-f16v2-beta-board.html

This item seems like it would give me 16 more strings but has to be in the same enclosure as the primary.

Thanks


2 Replies
Posts: 1420
(@1pet2-9)
Noble Member
Joined: 6 years ago
I am trying to determine how the remote node would look from something like the FPP software running on the primary controller.

When you go into FPP on the Kulp primary, you configure all the outputs, local and receiver alike. The receiver channels have their own special rows and are labelled as such.

Yeah, it's to run further distances. But also, there's a convenience factor. I believe the cat5e is rated to run 300m, but I have never approached the 100m mark yet. At least, not on the receivers.


Reply
Posts: 59
Topic starter
(@pyro2k)
Trusted Member
Joined: 5 years ago

Thanks for confirming. I am planning to migrate from a 4 port sandevices controller so everything is slightly new or different.


Reply
Share: